Data sheet of M5 optical displacement Sensors
(LED)
(fit to print)
M5 / |
2 |
4 |
10 |
20 |
100 |
200 |
|
| Range (mm) | ± 1 |
± 2 |
± 5 |
± 10 |
± 50 |
± 100 |
|
| Reference distance (mm) | 24 |
24 |
45 |
65 |
220 |
340 |
|
| Linearity error* (µm) | 6 |
12 |
30 |
60 |
300 |
600 |
|
| Resolution (Noise) (µm) | 0.5 |
1 |
3 |
6 |
30 |
60 |
|
| Spot diameter (mm) | 0.8 |
0.8 |
2 |
3 |
8 |
10 |
|
| Case drwg. (head + BOX ) | |||||||
| Optional protective cases | integrated , scratch or heat |
||||||
| Light source | LED, wavelength infrared 900 nm (not visible) |
||||||
| Internal sample frequency | 2.5 kHz |
||||||
| Analog outputs |
Voltage | ± 10V, approx. ± 14V |
|||||
| Impedance | < 0.1 Ohm (10 mA max.) |
||||||
| Angle error | 0.5%, tilted Object 30°, A-axis |
||||||
| Reaction time | 1 ms, 2 ms or 20 ms selectable |
||||||
| Bandwidth (-3db) | 500 Hz, 200 Hz or 20 Hz |
||||||
| Temp. coeff. | 0.03% / °K |
||||||
| Reflected light | +1 to +10 VDC, approx. 0 to +13 VDC |
||||||
| Digital outputs |
MIN | +24 VDC / 10 mA, active if below MIN, yellow LED on |
|||||
| OK | +24 V/10 mA, active if in-between MIN and MAX levels,grn. LED on |
||||||
| MAX | +24 VDC / 10 mA, active if above MAX, red LED on |
||||||
| Hysteresis | approx. 0.5% from range |
||||||
| Alarm outputs |
F1 | +24 VDC / 10 mA, active if not enough refl. light, yellow LED on |
|||||
| F2 | +24 VDC / 10 mA, active if too much refl. light, red LED on |
||||||
| Optional outputs | Other Voltages, Current (4..20mA), Serial (RS232) , Relay , thickness |
||||||
| Ambient light | approx. 20,000 Lux |
||||||
| Life expectancy | 50,000 h for power LED |
||||||
| Isolation voltage | 200 VDC, ground to case |
||||||
| Maximum vibration | 10g @ 1kHz (sensor head, 20g optional) |
||||||
| Operating temperature | 0 to +70°C (32 to 158°F) |
||||||
| Storage temperature | -20 to +70°C (-4 to 158°F) |
||||||
| Humidity | < 90 % RH |
||||||
| Protection class | Sensor head IP 64 , Electronic module IP40 |
||||||
| Power supply | +24 VDC, 200 mA (21 to 28 VDC) |
||||||
| Connector ( 25 pin D-Sub ) | |||||||
| Sensor cable | 2 m |
||||||
| Back | (*) Measuring on a white surface - Bandwidth set to 200 Hz | Home |